To Print these directions - In your browser, click Print from the File menu. This document will print to the correct width because of the word wrapping feature. Use Back to return to previous screen. ____________________________________________________________________________

Customer's drawing specifications

Which method you use will be depend on your situation and your abilities.  

WHAT ALL DRAWINGS MUST HAVE

1. Hole sizes should be approximately .010" larger than the diameter of the object using that hole.
2. Text sizes, specified if needed, otherwise standard sizes will be used.
3. Clearance zones are for a 'No text or graphics to be placed within this area'. These areas are for washers, nuts, screw heads, knobs, switches or instruments that mounts from the front and have a lip that is larger than the hole size.  Text and graphics will be placed outside of the clearance zone so that they will be visible.
4. Dimensions; length, width, hole and text positions, etc...
5. Name, shipping address, phone #, fax #, E-mail address and the date requested to be completed.

AutoCAD or other CAD program drawing specifications.

1. Explode all blocks (polylines are acceptable).

2. Color layers as needed (i.e. different size text, holes, etc).

3. Text, use the middle insert point. Use the standard "TXT" font (A.E.'s computerized engraving machines compensate and use a high quality font in place the "TXT" font. If any text uses any other type justification other that middle, place that text on a separate layer.

4. Placement of text. Draw a temporary line perpendicular from the center of a hole. Use "OSNAP" - "INS"ert Command to snap the text insertion point to the center line of the circle. Move text as needed keeping in mind the clearances for nuts, washers, etc.

5. Place all construction lines, notes, text and directions on any layer appropriately named. These are just examples.
   100 - All text to be .100" in height.
   030 - Graphic lines to be .030" in width.
   Notes - Any & all notes to you or Aircraft Engravers.
   Holes - All holes.
   Const - Any construction lines.

6. Clean-up drawing - Use the Purge command to clean up the drawing file of any unrelated entities if needed.

7. Label disk with your name & date. 

Drawing by hand

Just use 'What all drawings must have'.  

Grave stone rubbing method

Is the method of coping the recessed impressions on old grave stones.  As kids we used the sides of crayons and large clean news print paper.  You will need to tape a piece of paper over the area and rub a lead pencil over this area to get an impression of the holes and text. Mark what the actual hole sizes are. Measure and mark the distances to each edge.

Tracing